Hobbywing UBEC-10A V2 Car

Product detailed description

UBEC 10 A is a switched DC power stabilizer; it is powered by a 2-6S LiPo battery, reduces the input voltage to a level suitable for powering receivers and on-board electronics of RC models and stabilizes the output voltage at a set value (6.0 V, 7.4 V or 8.4 V). The load capacity of the UBEC is 10 A continuously, 15 A peak. Thanks to the waterproof and dustproof case, it is especially suitable for off-road car models, but also boats, tanks, etc.

• It uses an advanced DC step-down converter chip with protection against current and thermal overload operating with an efficiency of close to 90%.
• Small dimensions and low weight for easy use and installation.
• 3 output voltages (selectable using a shorting jumper) suitable for all types of receivers, servos and also LED lights, winches, etc.
• Indicator LED signaling the operating status of the UBEC.
• Metal electronics housing and ferrite ring on output cable to suppress electromagnetic radiation.
• External switch for easy on/off.
• Using UBEC

Electric drive model with OPTO controller: Connect the UBEC directly to the outputs of the drive battery and plug the UBEC output connector into the battery socket (or another free servo socket) on the receiver.

Electric drive model with controller with built-in power stabilizer (BEC): Before connecting the UBEC, you must disconnect the red wire (+) in the servo cable of the controller to disable the built-in BEC. Otherwise, the UBEC connection is the same as for the OPTO controller.

Combustion engine or motorless model: Connect the UBEC directly to the outputs of the power battery and plug the UBEC output connector into the battery socket (or another free servo socket) on the receiver.

Tip: To reduce possible interference, place the UBEC in the model at least 5 cm away from the receiver.

Application Car, Boat
Continuous current: 10A
Max. peak current: 15A
BEC voltage: 6 - 8.4V
Length: 45mm
Width: 20mm
Height: 16.2mm
Weight: 34g