Carson RC Reflex Wheel Pro 4 Electric-Set

Product detailed description

3-channel steering wheel 2.4GHz RC set suitable for controlling RC models. This professional remote control system offers many setting options that can be conveniently changed using the function buttons. Ergonomic handle and steering wheel at a comfortable 4-degree angle. Steering precision is increased by the use of a ball bearing on the steering wheel. The package includes everything you need to operate the model, such as a 4-channel receiver, 6kg steering servo, Charger for NiMH batteries, drive battery and transmitter batteries.

Package contents: Carson Reflex Wheel Pro 4 transmitter, 4-channel receiver (500501548), 6kg steering servo, Charger for 4-8 cell NiMH batteries, Drive battery 3000mAh/7.2V with Tamiya connector, 3x AA transmitter batteries, multilingual instructions.

Technical data:

• Transmitter operating voltage 3.6 to 4.5 V
• Receiver power supply (without BEC) possible from 3.5 to 10 V
• Channel 3 programmable as a button or switch (servo)
• Connector system for Futaba and Graupner-J/R
• Steering servo: 6 kg (JR connector)
• Charger: for 4 - 8 cell NiMH batteries, maximum output power 2 A
• Battery: NiMH, 7.2 V / 3000 mAh with Tamiya plug
• Transmitter batteries: LR06/AA 1.2 V

Features:

• 2 step-adjustable and fully proportional channels
• Ball bearing on the steering wheel for more precise steering
• LED battery status indicator
• Failsafe function
• Ergonomically shaped foam steering wheel at an angle of four degrees
• Waterproof* 4-channel receiver
• Servo reverse (reverses the direction of travel for channels 1 and 2)
• Setting trims for control and throttle
• Dual rate for channels 1 and 2 (limits steering and reduces speed)
• Memory for 15 models
• Range up to 200m

Pairing the receiver with the transmitter:

1. Turn off the receiver and transmitter
2. Connect the "pairing cable" to the pins in the PAIR position on the receiver (from the side of the receiver)
3. Turn on the receiver (connect the ESC or RX battery), the LED on the receiver will start flashing
4. Turn on the transmitter
5. Pull out the pairing jumper on the receiver, reinsert it and pull it out again in quick succession. The LED on the receiver will stop flashing and light up permanently. Pairing is complete.
6. Turn off the receiver and transmitter, remove the pairing jumper. After turning on the transmitter again, the receiver is already paired.

Note: Sometimes pairing is lost if the power battery is low. Always re-pair with fully charged batteries.