Receiver 4Ch Reflex Wheel Pro 4 WP

Product detailed description

4-channel receiver with FailSafe function. Receiver power supply (without BEC) is possible up to 6V. Designed for use with the Carson Reflex Wheel Pro 4 transmitter.

Warning: The original manual incorrectly describes the pairing procedure

Pairing the receiver with the transmitter:

1. Turn off the receiver and transmitter
2. Connect the "pairing cable" to the pins in the PAIR position on the receiver (from the side of the receiver)
3. Turn on the receiver (connect the ESC or RX battery), the LED on the receiver will start flashing
4. Turn on the transmitter
5. Pull out the pairing jumper on the receiver, reinsert it and pull it out again in quick succession. The LED on the receiver will stop flashing and light up permanently. Pairing is complete.
6. Turn off the receiver and transmitter, remove the pairing jumper. After turning on the transmitter again, the receiver is already paired.

Note: Sometimes pairing is lost if the power battery is low. Always re-pair with fully charged batteries.